Disclaimer:

Firearms are Dangerous. Review this operator’s manual in full before using your suppressor. Failure to follow the instructions could result in damage to your firearm or serious personal injury or death. Always follow safe firearm practices.

Product Overview

Off Grid Suppressors use state of the art manufacturing along with patented technology to bring our customers high performing suppressors. All of Off Grid Suppressors are single piece units with non-removable parts, the suppressors are direct thread units.

  • .22 Caliber - Titanium
  • 5.56 is manufactured in both Titanium and Inconel
  • 7.62 is manufactured in both Titanium and Inconel

General Considerations

Ammunition: Always use good quality factory new ammunition in your firearm. Avoid using Wildcat or reloaded ammunition with your Off Grid suppressor.

In order to reduce the risk of baffle strike, it is important to ensure that your barrel threads are aligned with the bore axis of your weapon barrel.

Direct Thread Installation

Off Grid Suppressors are manufactured with either 1/2x28 or 5/8x24 threads and the suppressor threads directly on the barrel. Check thread tightness often. All direct thread suppressors will loosen up with use. A loose suppressor will shift the point of impact and can also result in baffle strikes.

Before use, make sure that the suppressor is firmly and rigidly mounted to the firearm. Failure to do so could result in damage to your firearm and suppressor. Visually inspect the suppressor after it is mounted in order to confirm it is mounted straight to the centerline of the bore. If the suppressor is not in line with the bore do not fire the firearm.

Breaking-in Your Unit

Once properly mounted your suppressor requires break-in. The first shot may be compromised until the suppressor is shot 5 to 10 times after which it is broke-in.

CAUTION:

When removing the suppressor from your firearm be extremely cautious as the temperature of the suppressor could cause burns and or personal injury.

Cleaning

Off Grid suppressors require very little maintenance. It is important to keep the threads clean on both the suppressor and the firearm. Always use thread adapters on your firearm when the suppressor is not attached. Using a gun oil on the threads on occasion is recommended. There are no parts inside the suppressor as it is manufactured as one unit.

Each suppressor is finished with a high quality Cerekote. It is extremely durable and performs under high temperatures. It is important to understand that some solvents could be harmful to the exterior finish. Soaking the suppressor in solvents is not recommended. Do not run cleaning patches or use other methods of putting objects inside the suppressor to clean. Any questions regarding the performance of your suppressor please contact Off Grid customer service.

Disclaimer

Off Grid Suppressors is not responsible for damages or injuries due to the misuse or unintended use of its products. Firearms and firearm accessories are potentially dangerous. Precaution and safety must always be taken in order to prevent damage to your firearm, and or injury/death to yourself and others.

Registration & Warranty

In order to be registered for Warranty you must register your product: offgridarmory.us/product-registration-form

Off Grid Suppressors provide a lifetime warranty against all manufacturing defects and damages caused by the normal use of this product. The manufacturer will repair or replace free of charge any suppressor that is deemed defective under normal use. Conditions not covered under this warranty are but not limited to; modifications to the suppressor, abuse, neglect, use of low quality ammunition and or reloaded ammunition. Off Grid Suppressors assumes no liability or responsibility for damages and or bodily injury caused by such acts. Using this product in situations in which the product was not
intended can cause harm to the suppressor and or the operator.

Contact Off Grid for Warranty:

Call our service department at 218-657-2264 to work out arrangements for return of your suppressor for repair. Do not ship your suppressor for repair without contacting Off Grid. An Off Grid representative will provide next steps for shipping the units and provide the information required to ship such as BATF Forms.

LAWFUL USE AND POSSESSION:

Owning a suppressor is not legal in every state. Please understand your jurisdiction and the legal process for owning and possessing a suppressor in your state. If you have any questions regarding owning a suppressor please contact your local law enforcement or BATF office. It is important to understand that suppressors are an NFA item and highly regulated by the Government. Always maintain proper BATF documentation with your suppressor.